New Black 3d Printed 1/10 Scale Speed Kit Traxxas Bandit Rc Race Car

This is for the Speed Kit Only NO CAR INCLUDED! You will need to paint sand and assemble this yourself! No hardware included you will need to buy it to complete this kit. Comes in black but can come in different colors upon request! This is for 1/10 Scale car! Please make sure you have the correct car and scale before purchasing.
Outfit your Traxxas Bandit for some serious speed with these 3D printed parts. This includes upgraded wheelie bar and air splitter as well as ground effect plaits that are only available in this kit. Additional hardware for mounting and assembly are listed below. These parts where specifically designed to be functional yet easy to Install. All parts have been tested in both "speed run" and "drag race" applications.
DONT WAIT Get your Bandit Fitted for speed TODAY! MADE IN USA FREE USA SHIPPING
-TRAXXAS WING-
This is a three-piece wing designed for the Traxxas BANDIT and the (1:10) / (1:8) scale E-Revo.
ADITIONAL HARDWARE NEEDED
Eight 3X10mm screw (ONE TRAXXAS PART NUMBER  2587)
Eight 3mm nut (ONE TRAXXAS PART NUMBER 2744)
-BANDIT AIR SPLITTER-
This is a functional air splitter for the Traxxas Bandit. It will also fit the Traxxas 2WD Rustler but will require running front wheels from the Bandit. This splitter can be adjusted to produce significant down force to keep the bandit on the ground at high speed. It works best when used with a more aggressive rear wing. It is recommended to lower the ride height when using this splitter. This can be achieved by limiting straps or internal shock limiters (fuel tube on the internal shock shaft).
ADITIONAL HARDWARE NEEDED:
Two 3X32mm screw (ONE - TRAXXAS PART NUMBER 3964)
Four 3X20mm screw (ONE - TRAXXAS PART NUMBER 2580)
Two 105mm turn buckle (ONE - TRAXXAS PART NUMBER 2339)
Four tall hallow balls (ONE - TRAXXAS PART NUMBER 5355)
-TRAXXAS WHEELIE BAR-
This is a wheelie bar for all Traxxas 2WD 1:10 scale cars and trucks. Works with the stock Traxxas motor guard / wheelie bar mount. Pictured on the Traxxas Bandit and fits the Rustler, Slash and Stampede. This wheelie bar is designed with drag racing or speed runs in mind.
ADITIONAL HARDWARE NEEDED:
One 4X20mm screw (TRAXXAS PART NUMBER 2589)
One 3x15mm screw (TRAXXAS PART NUMBER 2579)
Four 3x20mm screws (TRAXXAS PART NUMBER 2580)
One 4x8x3mm bearing (TRAXXAS PART NUMBER 7019)
-TRAXXAS BANDIT GROUND EFFECTS-
Significantly increase down force on your Traxxas Bandit. Take advantage of ground effect with these plates available only in this Bandit speed kit.
ADITIONAL HARDWARE NEEDED
Four 3X10mm screw (ONE TRAXXAS PART NUMBER  2587) or Two sided servo tape.

Returns Accepted for this item if it's within 30 Days